Mechanical properties of the laser powder deposition and laser powder bed fusion printed 316L
Hietala, M; Rautio, T; Mäkikangas, J; Järvenpää, A (2023-05-04)
04.05.2023
M Hietala et al 2023 IOP Conf. Ser.: Mater. Sci. Eng. 1280 012018
https://creativecommons.org/licenses/by/3.0/
Content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI. Published under licence by IOP Publishing Ltd.
https://creativecommons.org/licenses/by/3.0/
Content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI. Published under licence by IOP Publishing Ltd.
https://creativecommons.org/licenses/by/3.0/
Julkaisun pysyvä osoite on
https://urn.fi/URN:NBN:fi:oulu-202401021035
https://urn.fi/URN:NBN:fi:oulu-202401021035
Tiivistelmä
Abstract
Metal 3D printing technologies have made it possible to produce different parts, but the mechanical properties of the parts connected using different 3D printing technologies have not yet been sufficiently studied. In the study, 316L stainless steel was laser powder deposited (DED) with laser cladding head on the laser powder bed fusion (PBF-LB) printed 316L and the joint was investigated experimentally. The microstructure of the joint was examined from the cross-sections of the joint by optical microscopy. The mechanical properties of the joint were evaluated by hardness measurements and tensile strength tests. The microstructure of the deposited structure was similar to the typical 316L printed structure, but at the joint, due to the higher heat input of the DED process, an increase in grain size was clearly visible. Based on the hardness measurements, the hardness profile of the joint was very even, and the average hardness was approximately 305 HV. The tensile strength of the PBF-LB and DED joint was 549 MPa which is approximately 11% lower than the tensile strength of PBF-LB printed 316L.
Metal 3D printing technologies have made it possible to produce different parts, but the mechanical properties of the parts connected using different 3D printing technologies have not yet been sufficiently studied. In the study, 316L stainless steel was laser powder deposited (DED) with laser cladding head on the laser powder bed fusion (PBF-LB) printed 316L and the joint was investigated experimentally. The microstructure of the joint was examined from the cross-sections of the joint by optical microscopy. The mechanical properties of the joint were evaluated by hardness measurements and tensile strength tests. The microstructure of the deposited structure was similar to the typical 316L printed structure, but at the joint, due to the higher heat input of the DED process, an increase in grain size was clearly visible. Based on the hardness measurements, the hardness profile of the joint was very even, and the average hardness was approximately 305 HV. The tensile strength of the PBF-LB and DED joint was 549 MPa which is approximately 11% lower than the tensile strength of PBF-LB printed 316L.
Kokoelmat
- Avoin saatavuus [38404]
Ellei muuten mainita, aineiston lisenssi on https://creativecommons.org/licenses/by/3.0/