Vanadium removal and floc characteristics of tannin biocoagulants and iron sulphate in the treatment of mine effluent

Abstract

<div lang="en" class="abs"><p class="abs_header">Abstract</p><p>This study compared the performance of tannin (quebracho and spruce) and iron sulphate (FS) coagulants for the removal of vanadium from effluent derived from an abandoned vanadium mine. The efficacy of the materials was studied at the natural pH of the mine effluent (7.4), and at adjusted pH levels of 4 and 9. The quebracho tannin coagulant (QT) recorded impressive turbidity and vanadium removals of above 88% over a wide pH range. However, the spruce tannin coagulant (ST) was not as effective at pH 9 (39%) although it showed an improved vanadium removal of 46% and 70% at pH 7.4 and 4, respectively. This was attributed to the lower charge density of ST than that of QT, and to a loss of cationic properties at pH 9. FS performed better in terms of vanadium removal (pH 4: 86%, pH 7: 98%, pH 9: 100%) with lower coagulant doses, although effective turbidity removal required precise pH control. QT produced the largest flocs and the highest floc regrowth at pH 4 and 7. Under alkaline conditions, tannin coagulants exhibit no regrowth, which implies that a careful flocculation and floc separation step is needed. The natural organic matter fractionation results revealed that FS effectively removed hydrophilic carbon (76%) in a pH-controlled mine effluent better than tannin coagulants (QT: 12% and ST: 22%) from the pH 4 effluent; however, ST removed hydrophobic carbon entirely. All coagulants adequately removed humic substances, with FS being the most efficient (88%), followed by ST (53%) and QT (47%). X-ray photoelectron spectroscopy (XPS) analysis of jar test residues showed that some of the vanadium removed existed in the V(IV) oxidation state.</p></div>