Building lumped models for measured passive mm-wave components
Sankila, Eero; Kiuru, Veeti; Aikio, Janne; Rahkonen, Timo (2018-10-30)
E. Sankila, V. Kiuru, J. Aikio and T. Rahkonen, "Building Lumped Models for Measured Passive mm-wave Components," 2018 IEEE Nordic Circuits and Systems Conference (NORCAS): NORCHIP and International Symposium of System-on-Chip (SoC), Tallinn, 2018, pp. 1-4. doi: 10.1109/NORCHIP.2018.8573484
© 2018 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works.
https://rightsstatements.org/vocab/InC/1.0/
https://urn.fi/URN:NBN:fi-fe201902074303
Tiivistelmä
Abstract
This paper presents a synthesis flow for building lumped circuit models of arbitrary complexity for mm-wave IC passive components, based on S-parameters obtained by measurements or electromagnetic (EM) field simulations. Lumped circuit models are needed in time-domain simulations, or to speed up the fine-tuning of passive circuit blocks, as iterating is much faster in circuit simulators than in EM simulator. Modeling algorithm is implemented in MATLAB, and the design flow has a few new features. The device model is given by Spice netlist, and its structure or complexity is not limited. Differential and common mode forms of admittance parameters are used to simplify solving the initial model component values that are then refined manually or by numerical optimization. The flow is illustrated by modeling a parallel LC resonator, whose response has been measured from 1 to 40 GHz
Kokoelmat
- Avoin saatavuus [37205]